Jupiter & Oncore GPS System and More .
Completed Interface Board Component Side Please NOTE Board has not been Trimmed
JUPITER GPS Engine Interface, This particular Board has been Produced Professionally From Gerber File as New Tracking Encoder Board was.
I hope this image will give everyone a better understanding of the application of the Jupiter GPS, Interface Board, etc, etc. NOTE: No computer Interface is shown, nor is any mention of the 1pps application that is also possible, and I am not sure why 1pps should be considered. Although any version of the Versatile CLPD PLL is capable of running 1pps using the larger 3064 device. Also a note of mentioning is that no 10Mhz Osc is required. I will cover the 10Mhz application at another time.????
OK having mentioned where n11, n12 & n13 are located in that first Image.....this Image will show you. NOTE: n0 to n10 has NOT changed, but n11, n12 & n13 & n14 are located on pins 18, 19 & 20 where the *R* Register pins are on Versatile 1 and Pin 15 is now n14, thus you 15 Binary Possibilities, or 111111111111111 which is Decibel repersents 32,767. Any XTAL can now be divided between 50 to 32,767
Calculate your *n* number On Line Versatile 4, This does not convert *n* to Binary.
Price $82.00USD Assembled & Tested Plus Shipping. To Place an Order
I have 3 ONLY Rockwell Jupiter Engines available complete with Jupiter Interface
This Unit can be packaged in a Box if you wish, please contact me
Short wmv movie showing Jupiter & PLL Locked to DEMI Micro-LO 180Mhz 7th overtone XTAL This is not very well done, I needed 1 more Arm & Hand. I was attempting to move the Locked Square Wave as shown on the XOR Line, XTAL was to hot to handle and blowing on it did not change much at all. A very Solid Lock for a 7th Overtone XTAL.
Short Quicktime MOV of First Interface Powered up. Evening News In the Back ground .....You will need Quicktime Player installed on your Computer.
Image of Jupiter GPS and Interface connected with Tac32 Antenna was sitting downstairs looking at the coupled output to my Z3801A, so really indoors below ground level. Comport Cable needed straight Serial Cable....NOT Null Modem, or Modem cable for Both Tac32 and any other NEMA Software.
Short Quick Time Movie, GPS Antenna setting on my Living Room Window Sill
Same Board with Jupiter GPS Mounter Hope to fire it up this evening
NOTE: Nothing is Solded in, header Pins just hanging in the holes
PLL Board Cost Loaded & Tested is $107.50USD Plus USPS Priority Post. Board Populated & Tested Cost. If you use PayPal, US & CND add 5%, International Add 7%
This Board is Binary Coded by 14 to derive the correct division ratio down to 10Khz, i.e. from 50 to to 32767 , so division N is n0 to n13, all 14 Pins are NOW n-1, Pin 15 becomes n14, Great stuff Guys. not many, if any XTAL's can not be locked to this Jupiter GPS and Interface,
Jupiner Interface PC Board This will be the New Board Silk Screening, or Overlay
Jupiter Data Sheet in PDF, Right Click and Safe as????
Anyone Interested in Purchasing This Board Please Contact Me, ve1alq"AT"nbnet.nb.ca
My GPS Receiver data outputThis Real Time Data is located on my QTH Front Page, that is running Apache and may, or May not be up and running???
Canadian Amateur Radio Station VE1ALQ & VE9DW
VE1XYL when allowed ( ;o}